2020-05-01から1ヶ月間の記事一覧
If it were bussiness, this makes less than 40% yield and is not enough to produce any profit but creating loss because the beans loose weight and the yield shrink down. Plus you need to select the beans to tune up the taste and their appe…
I found a way to adjust the front drum gap to minimum, to the point where you can't go any closer. It was possible to close it up much closer than cold position when it is hot enough to roast. Today I had to rotate the drum by my own hand …
I have been waiting for some components; the designated glue for the back panel heater is going to come next week and so on. And my sence of taste and smell have not yet recovered fully I suppose this is the reason why I cannot enjoy coffe…
I was looking through some old batches which I thought were useless, I found that the roasting had been going very smooth and almost perfect untill the drum stopped. So, I decided to restore one before last settings and try similar profile…
Now the cylinder is empty and the propane is gone. As I was checking the machine, I found that the nuts and poles on the back panel were so easy to remove that it gives me a good way to attach the external back panel heater. Today, I also …
Something I have written in past 30 minutes have all gone. Internet is very slow here via nuro. When the beans being heated up they release certain amount of steam and when they reach to the boiling point the pressure in the drum drastical…
It turned out that the influence of excess heat storage at the front panel can be avoided by slanting the machine to lean back by some degrees. Now all the moters working fine, I do not have to worry about the drum motor that used to stop …